this post was submitted on 01 Nov 2023
1181 points (100.0% liked)
196
16747 readers
1947 users here now
Be sure to follow the rule before you head out.
Rule: You must post before you leave.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Totally doable, use a multicolor printer and print it like 3 layers thick - you'll get thin flexible plastic sheets.
Not actually practical, but totally doable lol
Just do a midprint filament swap... Looking at getting into TPU at the moment, it might actually be a fun way to have my kid hand something short in. 3 layers of white, 0.12mm per layer, swap to black and print 3 layers more. I'd be concerned about stringing and delamination. But it's pretty close to the heated bed, so mostly stringing. Fuckit we're going to try!
Your now going to do this and report back right?
Actually, I was going to yesterday. But I will try to get to it this weekend. Am becoming a bit worried about warping though...
Engineering Method my friend