this post was submitted on 03 Aug 2024
37 points (95.1% liked)
Asklemmy
43777 readers
2316 users here now
A loosely moderated place to ask open-ended questions
Search asklemmy ๐
If your post meets the following criteria, it's welcome here!
- Open-ended question
- Not offensive: at this point, we do not have the bandwidth to moderate overtly political discussions. Assume best intent and be excellent to each other.
- Not regarding using or support for Lemmy: context, see the list of support communities and tools for finding communities below
- Not ad nauseam inducing: please make sure it is a question that would be new to most members
- An actual topic of discussion
Looking for support?
Looking for a community?
- Lemmyverse: community search
- sub.rehab: maps old subreddits to fediverse options, marks official as such
- !lemmy411@lemmy.ca: a community for finding communities
~Icon~ ~by~ ~@Double_A@discuss.tchncs.de~
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
My understanding is that pure sine is only needed for inductive loads, like motors. If you run a vacuum cleaner with modified sine, it'll sound bad, maybe not work, maybe something will overheat, etc.
Computer power supplies are resistive loads (although reading about it just now it's slightly more complicated than that) and they don't mind the modified sine.
Computers use switch mode power supplies. The first step is a bridge rectifier, they could run on a square wave or ~170vdc. Most have active power factor correction, which chops the incoming current up even more.
Cheap capacitive dropper power supplies won't like a modified sine. Simple motor loads won't either. If you're doing radio frequency work, it will be a huge source of noise but shouldn't damage anything.