this post was submitted on 22 Nov 2023
255 points (100.0% liked)

196

16509 readers
4000 users here now

Be sure to follow the rule before you head out.

Rule: You must post before you leave.

^other^ ^rules^

founded 1 year ago
MODERATORS
 
you are viewing a single comment's thread
view the rest of the comments
[–] MudMan@kbin.social 55 points 1 year ago* (last edited 1 year ago) (3 children)

OK, just to sanity check, because it's not clear from the comments below.

We all realize that metric areas do use hp for car engines as well, right?

And a lot of them also do inches for TVs, which is weird and forces you to go digging into the specs for the cm measurements whenever you want to see if a TV will fit in a space.

[–] BluesF@feddit.uk 20 points 1 year ago (1 children)

In the UK we use metric and imperial so you can buy things in kilos but also measure your efficiency in MPG. Welcome to the island of the future/past.

somewhere jacob rees mogg just let out a sob

[–] Fonderthud@lemm.ee 11 points 1 year ago (2 children)

Engine displacement is measured in liters or cc as standard. Harley Davidson demands in using cubic inches though.

[–] CADmonkey@lemmy.world 8 points 1 year ago

Its just the old air cooled dinosaur old-man Harleys that show their engines in cubic inches. Here's a 975cc Harley. Here is a 750cc Harley. The sportsters have been listed in cc's for decades.

Suzuki does it too, on their cruisers. Like the M109.

[–] MudMan@kbin.social 3 points 1 year ago (1 children)

I didn't know that and it is hilarious.

[–] CADmonkey@lemmy.world 2 points 1 year ago

Its also incorrect for about half the bikes harley makes...

And don't look too closely at cruisers from Suzuki.

[–] Still@programming.dev 10 points 1 year ago* (last edited 1 year ago)

we have to dig to the specs for tv size cuz the size of tvs is the diagonal screen area not the actual size

we use cubic centimeter for small displacement engines where the whole displacement is measured (is car) and cubic inches for the large ones where the displacement is measured per cylinder (ie trains)

yup, reciprocal area measurements are a pain