this post was submitted on 07 Nov 2023
1135 points (98.3% liked)
Memes
45545 readers
1071 users here now
Rules:
- Be civil and nice.
- Try not to excessively repost, as a rule of thumb, wait at least 2 months to do it if you have to.
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Only Satan would design a hole that is smaller than the end of a bent paperclip when the entire purpose of the hole is to put something into it.
How else can you sell an iPoker 4X?
You're still using the 4X? Lol, get yourself an 8Max and thank me later.
I did but I'm still saving up for the handle
For anyone else who ever has this problem, there are easier ways than a paper clip and hammer.
I have used pencil lead (0.5mm) successfully. You get a short piece and push hard, it might hurt your thumb a bit but it works. Obviously most needles work but I have used things like safety pins from the back of a shirt pin. I’ve also used the tip of mechanical pencils in a pinch. And if you’re crafty you can do something (carefully) with a toothpick and a knife to shave the tip down. Dumbest thing I’ve ever used is a disposable flosser that had a toothpick on the end. I also used that to clean USB C ports. All of these also similarly work on small reset buttons on routers and such.
I usually take a needle of some kind and clip the point off so it's not as sharp.
An earring pokey works too, just wipe off any schmutz
there must be an everyday item that functions as a makeshift alternative.
is there a name for the superfine point ones?
For a Korean, the hole doesn't need to be that big