this post was submitted on 14 Oct 2023
14 points (100.0% liked)

Home Improvement

9088 readers
9 users here now

Home Improvement

founded 2 years ago
MODERATORS
nichos@lemmy.world
nieceandtows@lemmy.world
Confound4082@lemmy.ml
nieceandtows@programming.dev
14
Need to fasten/glue roofing shingle type of stuff with something that actually hardens (lemmy.dbzer0.com)
submitted 1 year ago* (last edited 1 year ago) by diyrebel@lemmy.dbzer0.com to c/homeimprovement@lemmy.world
5 comments fedilink hide all child comments
 

cross-posted from: https://lemmy.dbzer0.com/post/6251091

I have this:

https://www.aquaplan.com/product/easy-band/

I need to attach it vertically to some thick hard rubber roofing. There is a small section of roof which should probably normally have a parapit but instead the roofing rubber is not backed by anything. Then below it is a wood panel. So when it rains sideways the water runs down the roofing rubber and behind the wood panel.

I just need a piece of shingle to divert water to the exterior side of the panel. Roofing glues are made to never cure. Probably rightfully so, but that probably wouldn’t work to attach a shingle vertically as gravity would over power that tar-like never fully dry stuff. I tried construction adhesive & it didn’t hold.

you are viewing a single comment's thread
view the rest of the comments
[–] diyrebel@lemmy.dbzer0.com 1 points 1 year ago

I don’t have anything specialized like simple green, but wouldn’t acetone or denatured alcohol make a decent primer? I think priming the smooth rubber surface should be the easy part but it’s the bitumen band that’s tricky. It has a sandy texture and sand crumbles off when I rub it. Perhaps I should steel brush it where it needs adhesive.