v1605

What's everyone playing? I'm enjoying Mr. Driller for the GBC.

Thought I would show this off here too.

. 3 MBC1, 1 MBC3, and 1 MBC30

I happen to have a board from my FunnyPlaying build so I figured I'd give it a shot. Used enamel wire to make the button contacts and got 3.3v from the cart slot. I also removed the caps as to not power any circuits that didn't need (CPU and RAM were donors to the other board). Power is provided via AA batteries.

An update to my previous post. I was able to improive the average lag by disabling the serial monitor, passing a reference of the controller to the polling logic (eliminating the need to loop over the current state and previous state to determine if buttons should be pressed), and adding a 1ms delay between loops (should have realized that the board need some down time between calls). I've added the code since I think 8ms is a perfectly good lag result for a diy project.

Took a badly marginal gba pcb and transplanted the CPU and RAM into this new motherboard. The soldering was a nice challenge but I had an issue with the cart slot. A pin was bent, so had to fix that before games would boot. Very happy with the result. I've uploaded a picture of the back of the shell as well. https://imgur.com/a/opXFA5B

Also in person, the plastic is not cloudy at all. The motherboard is here https://funnyplaying.com/products/gba-custom-upgraded-motherboard-replacement?variant=40990162059325

cross-posted from: https://lemmy.world/post/13199828

Printed using hatchbox wood pla. I had a few issues with standoffs but a little glue fix those right up. I'm very happy with the way it turned out. Just waiting on the release of flippy drive to call it complete.

Links to all the models I used:

https://www.thingiverse.com/tessa-wolf/designs https://www.printables.com/model/469283-gamecube-jewel https://www.printables.com/model/117561-gamecube-power-button https://www.printables.com/model/280005-gamecube-reset-button https://www.thingiverse.com/thing:2644517

Printed using hatchbox wood pla. I had a few issues with standoffs but a little glue fix those right up. I'm very happy with the way it turned out. Just waiting on the release of flippy drive to call it complete.

Links to all the models I used:

https://www.thingiverse.com/tessa-wolf/designs https://www.printables.com/model/469283-gamecube-jewel https://www.printables.com/model/117561-gamecube-power-button https://www.printables.com/model/280005-gamecube-reset-button https://www.thingiverse.com/thing:2644517

This was my attempt to create a a SNES to Bluetooth adapter. It works but the average latency was 18.35ms, which I think is too much to be considered a good controller.

UV printed shell, new battery, button LEDs, and new screen.

Here is the inside

cross-posted from: https://lemmy.world/post/11912700

I added some documentation on how I'm automating remote control inputs on the 4k. Examples include a template for an IR transmitter, a python script to parse profile information off the SD card for use in automation, and an example of selecting a custom profile based on its name. Hopefully it can be useful, if only just to give some interesting node-red examples.

I added some documentation on how I'm automating remote control inputs on the 4k. Examples include a template for an IR transmitter, a python script to parse profile information off the SD card for use in automation, and an example of selecting a custom profile based on its name. Hopefully it can be useful, if only just to give some interesting node-red examples.