Mechanical Keyboards

8845 readers

1 users here now

Are you addicted to the clicking sounds of your beautiful and impressive mechanical keyboard?
If so, this community is for you!

Here you can discuss everything about mechanical keyboards (and only mechanical keyboards).

Banner by Jay Zhang on Unsplash

founded 4 years ago

[Help] Single key inputting adjacent keys (Corsair K90) (lemmy.ca)

submitted 1 year ago* (last edited 1 year ago) by melonpunk@lemmy.ca to c/mechanicalkeyboards@lemmy.ml

2 comments fedilink hide all child comments

A few days back my keyboard went haywire with most key presses inputting garbage. This was after I spilled a glass of water on my desk. I didn't think any got on the keyboard, but the two issues happened too close together to not be connected.

After a little while most of the keys returned to normal apart from a few, that have constantly been inputting bad characters. The B and V key inputs BV, the N and M key inputs NM, and so on for the rest of the right adjacent keys. Then the NumPad - and * enter *-.

I've opened up the keyboard and cleaned it of the usual dust using cotton swabs, tooth brush and 99% ISO alcohol, to no effect.

I can't get into the front side of the keyboard so can't be 100% that I've removed anything caught in there.

I'm wondering what next steps I might be able to take on this. I'm guessing there's some bridge between the affected keys causing this, though I don't really know as I've no experience in this.

Any tips?

top 2 comments

sorted by: hot top controversial new old

[–] jenterrobahne@dormi.zone 3 points 1 year ago (1 children)

It's possible that you fried some diodes on that side of the board matrix, but it could also be that there's still some moisture in there. Compressed air to the back of the PCB can make sure it's dry.

It's possible to get to the back of the board and replace the diodes if you are comfortable soldering. You can see the back of a K70 here: https://youtu.be/ZeIqMQ2WDaY?t=340

I'd maybe consider this an opportunity to get a more disassembly-friendly mech, though...

[–] melonpunk@lemmy.ca 1 points 1 year ago

I'll try the compressed air route, Looking into the gap between the face and the board I can see dust in there still so I'll try and remove that. Hopefully that gets results before I venture down the soldering route.