this post was submitted on 21 Dec 2024
63 points (100.0% liked)
Chat
7507 readers
21 users here now
Relaxed section for discussion and debate that doesn't fit anywhere else. Whether it's advice, how your week is going, a link that's at the back of your mind, or something like that, it can likely go here.
Subcommunities on Beehaw:
This community's icon was made by Aaron Schneider, under the CC-BY-NC-SA 4.0 license.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
You might be able to slightly loosen the extruder, so it would chew through the filament rather than drag things around. That much force is not going to be good for the gears either.