this post was submitted on 27 Sep 2024
31 points (100.0% liked)

Australia

3612 readers
210 users here now

A place to discuss Australia and important Australian issues.

Before you post:

If you're posting anything related to:

If you're posting Australian News (not opinion or discussion pieces) post it to Australian News

Rules

This community is run under the rules of aussie.zone. In addition to those rules:

Banner Photo

Congratulations to @Tau@aussie.zone who had the most upvoted submission to our banner photo competition

Recommended and Related Communities

Be sure to check out and subscribe to our related communities on aussie.zone:

Plus other communities for sport and major cities.

https://aussie.zone/communities

Moderation

Since Kbin doesn't show Lemmy Moderators, I'll list them here. Also note that Kbin does not distinguish moderator comments.

Additionally, we have our instance admins: @lodion@aussie.zone and @Nath@aussie.zone

founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
[–] Evil_incarnate@lemm.ee 4 points 1 month ago (1 children)

Aussie in Finland here. We have an electricity system here with "spot price". I get charged a price per kWh depending on the forecasted supply (from producers) and demand (from history and other math) and it changes every hour. At the time of writing this it is 0.60 c/kWh (+margin+transmission+taxes for a total of 7.87c/kWh).

When demand is higher, like winter, and supply is lower (maintenance or faults or no wind), the price can go up to 30-50c, but when there is plenty of power about the energy price can go into negatives.

This makes an effect on usage and stabilises the system. But probably too hard to set up.

[–] dgriffith@aussie.zone 7 points 1 month ago* (last edited 1 month ago) (1 children)

You can get smart meters in Aus now with time of use metering. What needs to happen now is that those meters get a simple, non-cloud-connected way to let your appliances know when is a good time to start up.

So for hard wired devices like your hot water heater or your pool pump you could have a simple relay-like device in your fusebox that can be set to "turn on below X cents per kWh" and it will switch them as needed.

Your air conditioner could have a linked IR remote that turns it on early in the day of power is cheap and chills the house for the afternoon heat or runs it a bit cooler than usual if it is already running.

Your fridge or freezer could have an "extra chill" setting.

Your washing machine and dryer could have simple "start now" "pause now" interfaces and they could just operate during the day whenever.

All this could be done with some newer version of the X10 protocol, and it would be great to get something like that standardised and widespread.

[–] Evil_incarnate@lemm.ee 2 points 1 month ago (1 children)

Yeah... Usually I just check the price to see if I can sauna or not. It's by far the biggest user of power in my apartment.

[–] dgriffith@aussie.zone 2 points 1 month ago

Coincidentally I've been in Tampere for 6 months for work, going back to Brisbane on Monday. Being in a "short stay" apartment means that sauna power bills aren't my problem 😎