this post was submitted on 11 Feb 2024
9 points (100.0% liked)

Buildapc

3850 readers
44 users here now

founded 2 years ago
MODERATORS
Lemmenmo@lemmy.world
9
Display issue (lemmy.world)
submitted 10 months ago by Lime66@lemmy.world to c/buildapc@lemmy.world
32 comments fedilink hide all child comments
 

I finished building my PC recently. when I turn on the monitor when the computer isn't on, there's obviously no signal and I see the bouncing logo, but when the computer is on, it says that there is no signal, and that my monitor is going into standby mode, and the display turns off. my gpu seems to be working fine, and I reseated my ram. What should I do?

you are viewing a single comment's thread
view the rest of the comments
[โ€“] HeyJoe@lemmy.world 1 points 10 months ago (1 children)

I normally see this if there is an onboard display port. If you're not having any luck using only that port try removing the GPU and try again. Once you do get a display check BIOS for settings revolving around what to use if GPU is detected. Either that or you may really have a bad GPU?

[โ€“] Lime66@lemmy.world 1 points 10 months ago

I have a 7800xt. don't know if that would cause a problem