this post was submitted on 06 Dec 2023
16 points (100.0% liked)

Ask Electronics

3313 readers
12 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 1 year ago
MODERATORS
DavideAndrea@discuss.tchncs.de
linker3000@discuss.tchncs.de
16
Designing a synth bipolar PSU inspired by Doepfer's A-100 PSU3 (i.imgur.com)
submitted 11 months ago by wfh@lemm.ee to c/askelectronics@discuss.tchncs.de
2 comments fedilink hide all child comments
 

I'm planning to make a modular synth from scratch, but I need to start with the PSU. Do you see any issues with this schematic?

The main difference between this design and traditional linear PSUs is the replacement of the transformer/rectifier/filter circuit by Mean Well IRM AC/DC converters. The linear regulation circuit is basically the reference design for the 78xx/79xx.

Do you think there would be an issue once scaled? The AC/DC converters have a lot of headroom, as I plan to make up to 3 regulation circuits like so:

full schematics

(the regulated outputs will actually never go nowhere near 1A per rail)

you are viewing a single comment's thread
view the rest of the comments
[–] wfh@lemm.ee 1 points 11 months ago

The linear regulators are still there. It's the rectifier that gets replaced. I guess the main difference in the power side is the high frequency noise of the switching PSUs vs the low frequency ripple of the rectifier, I'm not 100% sure if 7x12s are immune to them at least at audio frequencies.