this post was submitted on 02 Dec 2023
651 points (92.7% liked)
Technology
60131 readers
3062 users here now
This is a most excellent place for technology news and articles.
Our Rules
- Follow the lemmy.world rules.
- Only tech related content.
- Be excellent to each another!
- Mod approved content bots can post up to 10 articles per day.
- Threads asking for personal tech support may be deleted.
- Politics threads may be removed.
- No memes allowed as posts, OK to post as comments.
- Only approved bots from the list below, to ask if your bot can be added please contact us.
- Check for duplicates before posting, duplicates may be removed
Approved Bots
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I'd be concerned with the amount of unsprung weight this adds, too. You're basically taking the transmission and adding that mass to the hub. Seems like it would be pretty crashy on rough surfaces.
Yep.
Trucks used these as far back as pre-WWII. It a great solution for off road vehicles to gain clearance. At low speeds, even universal joints work fine for this setup, because the shaft rotates at 1/3 wheel speed, like a drives haft does going into a differential.
This puts a diff at each wheel.
Edit: These are called Portal Gears
Not quite portal gears, that has the input shaft fixed at the top. This is like an adjustable portal gear.
Meh, it's still a portal hub, where you put the input shaft is a minor difference. It's still putting the gearset in the hub, increasing the total weight of the vehicle, and increasing unsprung weight.
Calling it a new thing is a lie. All they've done is switch it to planetary gears. I'd bet lots of money this was tried a long time ago, and was shelved in favor of an offset input shaft.