3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
I was doing some bike maintenance today and wanted to disassemble my rear hub. It turned out that I needed a 12mm Allen bit for that, which I don't have. So I 3D printed one! And it worked! Torques safely to 5Nm and I only needed 4Nm for the job. Haven't tested higher torques.
A 3d printed caliper is not a bad idea, but the shape isn't always great for working on cars and bikes. A vertical telescope mimics the approach of the tool. Its something trivial enough I would probably never buy it, but might print it.
You could use a divider caliper to be able to translate the size of a fastener to a spot that is easier to measure, if you don't have to swap between inches and metric it would probably be easy to be accurate enough with it without much practice.